- Buy Sell Wholesale
Assember Upgraded version base on Super-X: Use 1.5mm ouput shaft instead, and use 1.5mm prop; Simplify the installation of flight controller, no small screw nor copper bush; Adopt the Split Type Design. Integraded USB functionon flight controller.
Only 62.5g! Super-X is one of the lightest and smallest brushless quadcopter on the market. It is installed Naze32 Flight Controller, built in recever, there are 3 optional compatible receiver: 1> DSM2/DSMX;2>Flysky;3>Futaba SFHSS. It comes with 4 set of brushless power system providing double thrust of its own weight, so it is easy for 3D flying or installing FPV system etc.
Weight:38.2g (not including battery), 62.5 (including one 300mAh7.4V battery)
Brushless motor: MP-03 (3g, 4000KV)
Flight Controller: Scisky 32-X 2S(integrated receiver optional, support Flysky, FUTABA SFHSS and DSMX/2, support Baseflight and Cleanflight)
Specification of Flight Controller:
Micro Size without case
Supper Light, with built-in receiver
Working Voltage: X Type 3.3-4.5V or 5-10V
12M/10PPM Crystal Oscillator
Support Receiver: DSM2/DSMX,FUTABA SFHSS,Flysky
Can choose external receiver which compatible with DSMX/DSM2 or FUTABA SFHSS Receiver
With X Type 1.5mm terminal, built-in DCDC boosted circuit(5V/500mA Output), support external power supply
Independent connectors for IIC,GPS,PPM/DSM/SBUS Receiver
Blue: Flight Mode
There is a RX-S connector(1.25mm 3P) on X TYPE used for external receiver, supports PPM,DSM2/DSMX,SBUS signal input,and 3.3V or VIN ouput. Player can use different external receiver by short connect the pad on RX-S connector and change the receiver type on GUI. X Type support DSMX/DSM2 or FUTABA SFHSS receiver.
1> X tpye support inversion signal
2> When the VIN output is higher than 5.5V, please make sure what the voltage input of external receiver before you connect it, to avoid to burn the receiver.
3> Even if the integraded receiver has been set in output disable, the external receiver can work still.
1. Supports 4CH or above transmitter, tuner or external receiver.
2. Supports 2S LiPo charger
1. Press the receiver frequency switch and supply power to Scisky 32-X flight control board, then loosen the switch, green LED flashes (receiver into the frequency mode);
2. Press the frequency switch, then turn on the power;
3. When the receiver green LED flashes into a constant light, the frequency is success, otherwise repeat the above steps.
1 x Super-X V2 Frame Kit
1 x Scisky 32-X 2S Flight Controller
4 x MP-03 Motor
4 x MU-3A ESC
1 x 2S 300mAh 25C Battery
8 x 75mm Prop
1 x Tie
340 total views, 1 today